Twist the RxD and TxD lines together. They might help someone else out. Tem algumas coisas interessantes. Can you do me and all the future readers a favor and measure the maximum current you can draw? The first thing you have to do is go to […]. However, mine only has 4 wires, and they connect to instead of 4 Victor March 15, at 2:
|Date Added:||2 November 2013|
|File Size:||14.21 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
You should double check your work because the wires are very thin and the pins are small and close together. Select the destination folder where dmu want to install PC Suite. It save me half of the cost! Unplug the USB cable.
PROLIFIC DKU-5 DRIVER
It’ll finish installing and you’ll get the success screen. Are you an engineer or working for Nokia? Then and only then should you install the correct version of Nokia PC Suite for your specific phone. If it still doesn’t work, try unplugging the cable from the computer and phone and then connect them again.
Get a free blog at WordPress. Wear an anti-static wrist strap. Some people end up with 3 wire cables while others get 4 or 5 wire ones.
PROLIFIC DKU-5 DRIVER
Installing PC Suite The installation is pretty straight forward. Assuming you’re pfolific a cable, select the ‘Cable connection’ radio button. There’s a nice tutorial out there somewhere for the same thing.
Carrington Theme by Crowd Favorite. Make sure the power is off and the cable is not plugged into the USB port. Well, I ask the moderator HF 25 to help me with this sticky thread.
If you try to exceed mA, bad things can happen. Just saw your post on the Arduino forums.
Ports – DKU-5 – DKU-5 Computer Driver Updates
Click the option marked ‘Manage Connections’. The other wires are not needed for communicating with your ATmega; nonetheless the pin 3 wire measured 0V and the pin 4 wire measured 3.
If you hold the button too long Arduino will eventually give up and report that the programmer is unavailable. So it sounds like you already have 5V brought out to the end of your cable.
If it worked, then that’s it. I looked into this, but my memory is a bit hazy on the details. Unfortunately the cable reports itself as a low power device. I’ve noticed that I need to connect the cable to the phone first and then to the computer. Recent versions of Dkku have the driver pre-installed. Try it on another computer and with another phone to make sure there pprolific a problem with either your phone or your cable.
Finally you should get the message saying ‘Your new hardware is installed and ready to use’ I’m not sure if you need to, but I disconnect my cable at this point before connecting with my phone. Not all pins will have a connection.
Wait for sometime, usually about 30 seconds or so, for PC Suite to detect the phone. April 27,7: The methods described here should work in general for cables using different chips.
Email required, but never shared.